3/16/2023 0 Comments Wireshark mac address monitor![]() ![]() It is like if you have removed the destination port and put it in a special state ( to be noted the destination port is considered down (monitoring) by the switch and without additional commands you cannot use it for accessing the network) dedicated to this monitoring task. It is not a problem what Vlan the destination port belongs to as actually it is configured to be the destination of a SPAN session. ![]() In this case you can use RSPAN as no routers are on the path and you have end-to-end L2 connectivity. If not ,How can we monitor traffic using wireshark in above case? If yes, How does Sw1 determine the destination port F1/2 is located on different switch sw3? We wish to capture traffic sw1's f1/1 using wireshark connected to sw3's f1/2. What about if the source port is located on different switch as shown below: Monitor session 1 destination interface FastEthernet1/2 Monitor session 1 source interface FastEthernet1/1 both Here source port and destination port both are on the same switch.I used these commands on sw1 and I was able to capture traffic : I encountered a situation where i had to monitor traffic on a switch port using wireshark as shown below: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |